Jaybird1980
Grandmaster
What's the minimum torque on the nut, and what kind of preload were you turning at that?I went to the site. It states in the description that they made out of paper. What's up with that?
BTW, I put it together tonight to see what kind of pattern I had. I hit the min required torque and then some on the pinion nut with .006" backlash. The drive side of the ring pattern was in the middle, both top to bottom and side to side. On the coast side I was in the middle top to bottom buy skewed to the toe side.
Not sure if I want to live with that or not. I still have to oil everything better, put the old nut on and go through the process again. And then check to see if anything has changed.
Then if it's okay, remove the old nut and put a new one on. And of course check it again.
Or I can accept defeat and take it to a shop. It will probably cost me about $300 to have them set the ring and pinion only.