The Official Status Update Thread: Part 87 -RoboCop

[GLOCKMAN23C]

Have a good one CM! Hope everything goes smoothly tomorrow.

 

[GregD]

Hi JD, that is a good one

 

[GregD]

I've got an early morning also. Just not a lot of work like CM. But, early, see you all tomorrow.

 

[jdmack79]

After dealing with the public at a "hunting" store today, I hope a few deer take out one or two of our rude customers in a similar manner.

 

[GLOCKMAN23C]

Have a good one Greg!

 

[GLOCKMAN23C]

After dealing with the public at a "hunting" store today, I hope a few deer take out one or two of our rude customers in a similar manner.

I can understand that. There are days when I wish a car would fall off of a lift on some people's heads.

 

[Sylvain]

 

[Caleb]

 

[DoggyDaddy]

Good morning INGO! Did everyone remember to set their clocks back last night? I did... But so much for getting an "extra hour" of sleep... I just woke up an hour earlier. Actually I woke up at the same time, but the clock said it was an hour earlier...

 

[churchmouse]

I woke at my normal 6:00 AM only to find it is an abnormal 5:00 AM.........:

 

[DoggyDaddy]

Mornin' CM! I started waking up a little before 3 a.m. (EST)... kept fighting it then got up at 3:30. Colts have a night game, and NASCAR doesn't start until 3:00, so I'm thinking a nap will be in order this afternoon!

 

[churchmouse]

Mornin' CM! I started waking up a little before 3 a.m. (EST)... kept fighting it then got up at 3:30. Colts have a night game, and NASCAR doesn't start until 3:00, so I'm thinking a nap will be in order this afternoon!

We have a huge day ahead. Have to finish the A/C part of the install we started yesterday. There is a family function today at 4:00. No range time for -CM- today darn it.
No football or NASCAR either.

 

[DoggyDaddy]

I had a busy day yesterday cleaning up storm damage (tree branches) from Thursday night. I'm heading down to Bargersville now for the flea market. Gonna mulch leaves when I get back. I think my next range time will be Veteran's Day. Outta here for now. Have a good day CM! Don't work too hard!

 

[SEIndSAM]

Goooooood morning INGO!!!

 

[Caleb]

Goooooood morning INGO!!!

 

[GLOCKMAN23C]

ARRRRGGG.....My truck is back on 4 wheels, but I cannot figure out this random/multiple cylinder misfire. Wires are hooked up correctly. I'm at a loss.

 

[Caleb]

ARRRRGGG.....My truck is back on 4 wheels, but I cannot figure out this random/multiple cylinder misfire. Wires are hooked up correctly. I'm at a loss.

rotors and caps? fouled plugs? bad ignition coil? bad distro? bad wires?

Have you performed a compression test?

 

[GLOCKMAN23C]

rotors and caps? fouled plugs? bad ignition coil? bad distro? bad wires?

Have you performed a compression test?

New cap, rotor and plugs. Coil, wires, ICM off of old engine (no problems when taken off.)

The computer is retarding timing, 16 deg @ idle, and 20-28 deg under load. Distributor was marked (multiple locations before removal), and aligned with those marks when installed. I'm not getting a code for the distributor being off a tooth. I'm leaning more towards a fuel issue. (CFM module)

 

[SEIndSAM]

Gooooood afternoon INGO!!!

 

[GLOCKMAN23C]

Howdy, Sam!