1911 this thing is torn apart now, post some pics of Harrys wiring organization when you get a chance.
Thanks.
I will be over there tomorrow, I will get pictures!
1911 this thing is torn apart now, post some pics of Harrys wiring organization when you get a chance.
Thanks.
If I knew more about electronics before building this I would have known that 16 AWG is too thin for the amps being drawn. I did not even know how many amps that was. The build instructions do not specify, but show using the speaker wire that was referenced in the parts needed. Which was 16 awg. Literally following instructions can get you in trouble.
Colin says I can double up the two ramps power wires and fan on a connector then have the heat bed on its own. Newer kits have the relay already attached.
Picking up some 12 or 10 AWG on way home from work and will see if it works.
Wondering if auto bed leveling will fit with those dual cooling fans. Thats a lot of crap hangin on that hot end.
Whats the issue? I hate that.
I am going to enclose the top of the printer with thin plywood I have on hand the sides with some foam board on hand but want the front clear. What type of plastic should I look for? Something easy to cut and cheap would be great.
Also going to print a 40mm fan mount to blow on that ramps board just for giggles.
Whats the issue? I hate that.
I am going to enclose the top of the printer with thin plywood I have on hand the sides with some foam board on hand but want the front clear. What type of plastic should I look for? Something easy to cut and cheap would be great.
Also going to print a 40mm fan mount to blow on that ramps board just for giggles.
I have been running 60mm sec for printer parts in PLA, going to start increasing that to see how fast I can reliably go.
One of the nuts on my Z axis will drop out of that printed guide if I raise the carriage too fast. Any ideas on how to lock it in? Thats a crappy design also. It should have been an insert on the side with a smaller hole through for the rods.
Good tips on plexi thanks.