Here was my 'final' project. I decided to create two rings...
The definition is quite clear in the model... granted, these are fairly small (ring sized)...
Vs. the real counterparts. focus was hard to obtain, but enough detail is visible to show there was little difference between the two printed rings... also, to note the interior of the rings should have been 'smooth', but shows the roughness I spoke of earlier. It is after all, melted plastic
The one on the right had some holes visible through the wall of the ring. it would have been about .25 mm thick
The definition is quite clear in the model... granted, these are fairly small (ring sized)...
Vs. the real counterparts. focus was hard to obtain, but enough detail is visible to show there was little difference between the two printed rings... also, to note the interior of the rings should have been 'smooth', but shows the roughness I spoke of earlier. It is after all, melted plastic
The one on the right had some holes visible through the wall of the ring. it would have been about .25 mm thick