What was the speed you were running on the mill? This is a great idea.... Would like to see the results with a new sharp tap.Mill shenanigans.
Playing around with angle of bevel on the lower slide edge. 5 degrees (shown on slide) made for too tall of a cut. 10 degrees (on the smaller rectangle test piece) was exactly what I was looking for. Not taking off too much material while giving the exact look I want.
View attachment 302433
And recorded an episode of "Why he do dat". Today's episode "Internet says you can cut slide serrations with a modified tap". It actually works!!! I could only find one spare tap that fit any of my collets though (M7-1.0).
Yes, I know my test piece is sticking out way too much from the vise. Better results with a new tap and a more rigid test piece.
View attachment 302435
View attachment 302436
View attachment 302437
View attachment 302438
Around 1000 rpm, the problem I had was finding a tap that would fit a collet, that one fit my 1/4 collet perfectly.What was the speed you were running on the mill? This is a great idea.... Would like to see the results with a new sharp tap.
Like cocking a cannon!Around 1000 rpm, the problem I had was finding a tap that would fit a collet, that one fit my 1/4 collet perfectly.
`Is this the FGE of the double stack 1911ish pistols?
I’m only bringing three…Is this the FGE of the double stack 1911ish pistols?
Morning WT.
Morning WT.
Dibs on the CTSI’m bringing my SA DS too. Just CZ styled. ;-)
Dibs on the CTS
Calling her your executioner seems a bit harsh.You’ll have to speak with my executor about that.
On a roll, he is.Maybe you should have finished that bathroom before it got to that point?
Calling her your executioner seems a bit harsh.