I finally ordered the sizing plates for 9mm and 45ACP for my Case Pro 100. Have about 10k casing to size and load. Since no one is making an auto-drive at the moment, I'm going to look like Popeye before I'm finished.
Loaded 100 rounds of 9 mm (115 gr plated RN over 4.4 gr W231) with my new Lee Classic turret press and Auto Drum powder measure. It's a nice upgrade over my old 90's vintage Lee value turret press and Auto Disk powder measure.
200 .38spl primed cases, these will be Trail Boss plinkers.
150 .357mag primed cases, these will be hotter 158 Lil'Gun loads for my R92.
After those i will be getting into my primer stash for some 32mag and 9mm.
Then a lot of spent primers to remove amd cases to prep in all the above. I have pretty good success with the straight wall cartridges, not so much with the 9mm but going to give it another try now that I have a factory crimp die.
On the .270 I loaded up years ago on 130 gr Hornady SST with the polymer tip and love them. Unfortunately they were impossible to find so I ended up with 130gr interlock soft point this batch. We will see if it effects my groups any, I hope not.
Finally got back to the final trim process and case gauge check on 150, AAC 300 Blackout cases made from once fired 223 Rem. today. Hopefully I will receive my order for more 30cal. bullets soon to continue the festivities!