First off thank everyone for all their help so far. You’re all wonderful.
I’m wanting to start loading some plinking rounds for my little 38 special.
In the past few months I’ve used a lot of acme and Berry’s. I like both. But wanted to start my 38 special journey with acme.
I purchased some of these lubed acme bullets.
I’m assuming I need to purchase a roll crimp die. Correct me if that’s not needed with that groove in the projectile.
I bought a hornady custom grade die set 38/357. I’m pretty sure it is a taper crimp.
Any advice on getting me going on this bullet?
I’m wanting to start loading some plinking rounds for my little 38 special.
In the past few months I’ve used a lot of acme and Berry’s. I like both. But wanted to start my 38 special journey with acme.
I purchased some of these lubed acme bullets.
38 CAL 125 Grain FP
ACME Bullet Company manufactures 38 Cal 125 FP (flat point) hard cast bullets and offers a variety of reloading supplies.
www.acmebullet.com
I’m assuming I need to purchase a roll crimp die. Correct me if that’s not needed with that groove in the projectile.
I bought a hornady custom grade die set 38/357. I’m pretty sure it is a taper crimp.
Any advice on getting me going on this bullet?