At the end of a hurried loading session yesterday, something caught my eye, falling from the right side. I assumed it was a case jamb up in the case feeder and brass was falling.
Looked up and the feeder was fine, looked down and found this pin on the floor. (Next to case gage for size.)
I verified everything was working and set, loaded one last round and covered the machine. All rounds passed inspection were tossed in the bag and I was off to the range to meet friends.
I did take a cursory glance and could not find where this pin came from, again a hurried one.
Anyone recognise what this pin came out of?
Thanks in advance.
Looked up and the feeder was fine, looked down and found this pin on the floor. (Next to case gage for size.)
I verified everything was working and set, loaded one last round and covered the machine. All rounds passed inspection were tossed in the bag and I was off to the range to meet friends.
I did take a cursory glance and could not find where this pin came from, again a hurried one.
Anyone recognise what this pin came out of?
Thanks in advance.