straittactical
Sharpshooter
- Dec 16, 2008
- 403
- 34
I have a Glock 19 Gen 5 that is NOT cut for a red dot. I am thinking about jumping down the red dot rabbit hole. I have a few questions if you guys could provide your opinions on.
1.) is it better to have my current Glock 19 slide cut or buy a new Glock 19 that is cut from the factory? And why?
2.) who is the best at preforming this work and what is a average cost? Does the whole slide need to be refinished?
any advice would be greatly appreciated.
1.) is it better to have my current Glock 19 slide cut or buy a new Glock 19 that is cut from the factory? And why?
2.) who is the best at preforming this work and what is a average cost? Does the whole slide need to be refinished?
any advice would be greatly appreciated.