I've been thinking about getting into bullet casting and could use some guidance. I'd likely be casting for 45 acp, 45 colt, 44 mag, 357 mag, and 9mm. I think I would also powder coat.
I've been looking at Lee molds, but not sure if I should start out with 2 cavity or jump straight to 6 cavity? I'm also thinking I can use the same bullets for the 45 acp (1911) and 45 colt (revolver and lever action) if I go with the right mold and sizing dies? I'm eyeballing the Lee TL452-230-TC, would that work? Same thing with 357 mag (revolver) and 9mm (semi autos)? I'm thinking about the Lee 358-125-RF for that. Then the appropriate sizing dies to size for 358 and 356?
Any bullet casters out there that can give a newbie caster some guidance? Thanks!
I've been looking at Lee molds, but not sure if I should start out with 2 cavity or jump straight to 6 cavity? I'm also thinking I can use the same bullets for the 45 acp (1911) and 45 colt (revolver and lever action) if I go with the right mold and sizing dies? I'm eyeballing the Lee TL452-230-TC, would that work? Same thing with 357 mag (revolver) and 9mm (semi autos)? I'm thinking about the Lee 358-125-RF for that. Then the appropriate sizing dies to size for 358 and 356?
Any bullet casters out there that can give a newbie caster some guidance? Thanks!