Everytime I load, I seem to end out with further questions. So sorry about that. I’m getting better but have a feeling this is going to take a long time to be happy with my loads.
I was using 124 RNHB Berry’s Bullets.
I thought i would try the acme bullets to save a few buck and see how they work.
I’m noticing that in my case gauge, everything looks fine. Then when I go to do the plunk test on my P10f barrel, if does go in fine. But it is just a hair higher than the Berrys bullets. I haven’t tried to shoot them yet but can’t figure that out.
I measure every single cartridge and lengthwise they should be the same. I need to check the diameter of the acme to the Berry’s.
Has anyone come across this and is this anything I should even spend my time worrying about?
I was using 124 RNHB Berry’s Bullets.
I thought i would try the acme bullets to save a few buck and see how they work.
I’m noticing that in my case gauge, everything looks fine. Then when I go to do the plunk test on my P10f barrel, if does go in fine. But it is just a hair higher than the Berrys bullets. I haven’t tried to shoot them yet but can’t figure that out.
I measure every single cartridge and lengthwise they should be the same. I need to check the diameter of the acme to the Berry’s.
Has anyone come across this and is this anything I should even spend my time worrying about?