My reloading table is somewhat low, so a long time ago I had ordered a strong mount for my Dillon Square deal press. The strong mount gave me the height I needed and It works just fine.
Anyway I recently ordered a RL550 press from Dillon, while ordering I figured I would get a Strong mount for the new unit...well maybe not...
The mount was $59.95 shipped... I don’t remember paying that for my Square deal mount 14 years ago, and dang I like the added height for the table I work on but heck call me cheap I thought that a bit much.
So long story short I made my own out of some scrap 1/8 sheet metal I had lying around my garage. The whole project from cut to weld, clean and then paint took less than an hour.
Can"t wait till the unit arrives... I'll drill the holes, mount it and get this puppy up and running
Oh and I’ll use the savings to buy some more powder
Here’s some pic’s enjoy!
Anyway I recently ordered a RL550 press from Dillon, while ordering I figured I would get a Strong mount for the new unit...well maybe not...
The mount was $59.95 shipped... I don’t remember paying that for my Square deal mount 14 years ago, and dang I like the added height for the table I work on but heck call me cheap I thought that a bit much.
So long story short I made my own out of some scrap 1/8 sheet metal I had lying around my garage. The whole project from cut to weld, clean and then paint took less than an hour.
Can"t wait till the unit arrives... I'll drill the holes, mount it and get this puppy up and running
Oh and I’ll use the savings to buy some more powder
Here’s some pic’s enjoy!