my diagnosis of frequent stove piping in my Beretta 92fs Enoch is a change of extractor, extractor spring. I have purchased replacement extractor spring from Wilson Combat. Now I have to knock out extractor pin. I do not have a punch size to accomplish this. I have searched Brownell’s and found a Beretta kit for “all” punches needed to work on #92. Reviews of this kit are horrible. So, I do not want spend $50 on that. I am looking for Input on size/diameter of pin and size and Quality of punch to do this job. If after I remove extractor itself I see that it is damaged I will replace. Brownell’s have these in stock. Also, I assume you remove from inside slide upward out though the top of slide. Right? Your time and guidance is much appreciated.
Bull Montana
Bull Montana