Thanks again. I can't recommend their work enough. Phil was very patient with me during my recent 80% lower projects.
I began discussing options and pricing last winter, before taking the plunger and purchasing some 80% lowers, in order to have a blank slate to work with for custom engraving and graphics. Because I am not a machinist, I wanted to wait until I successfully milled the lowers before spending time and money on the engraving. Phil was really patient with me during all of this.
Finally last week I sent my lowers off to him, stating that I was in no hurry, having taken a long time to get to this point. To my surprise, a week later, I had photos of the finished lowers and they were shipping back to me.
Phil assured me the engraving would be deep enough to accommodate cerakoting, anodizing, etc...
What I didn't expect, was this type of precision... amazing!
I would not hesitate to use Veritas for custom engraving work like this in the future! Simply phenomenal! I now have some one of a kind pieces!
NOTE: Tooling marks are from original billet machining. Next step is to media blast and coat these.
Just a follow up. After Cerakote & color fill, here is a photo of one of the lowers. The engraving is still plenty deep enough! I'm thrilled!
I began discussing options and pricing last winter, before taking the plunger and purchasing some 80% lowers, in order to have a blank slate to work with for custom engraving and graphics. Because I am not a machinist, I wanted to wait until I successfully milled the lowers before spending time and money on the engraving. Phil was really patient with me during all of this.
Finally last week I sent my lowers off to him, stating that I was in no hurry, having taken a long time to get to this point. To my surprise, a week later, I had photos of the finished lowers and they were shipping back to me.
Phil assured me the engraving would be deep enough to accommodate cerakoting, anodizing, etc...
What I didn't expect, was this type of precision... amazing!
I would not hesitate to use Veritas for custom engraving work like this in the future! Simply phenomenal! I now have some one of a kind pieces!
NOTE: Tooling marks are from original billet machining. Next step is to media blast and coat these.
Just a follow up. After Cerakote & color fill, here is a photo of one of the lowers. The engraving is still plenty deep enough! I'm thrilled!
Last edited: