I am getting ready to work up a load for my fullsize kimber and have a couple questions regarding where to start. I have loaded revolver (45 long colt), but really didn't worry about overall length and found a couple good loads. Just not sure where to start with the load for the auto.
Is there a way to measure what an optimum overall length would be?
Do I start with some variations of overall length keeping the powder constant?
or
Do I start with a constant overall length and vary powder?
I plan on evaluating both parameters, just not sure where to start. Any input on 45 auto loading would be appreciated.
BTW...I will be using RCBS carbide dies with a Lee Factory crimp die.
Is there a way to measure what an optimum overall length would be?
Do I start with some variations of overall length keeping the powder constant?
or
Do I start with a constant overall length and vary powder?
I plan on evaluating both parameters, just not sure where to start. Any input on 45 auto loading would be appreciated.
BTW...I will be using RCBS carbide dies with a Lee Factory crimp die.