Speers manual says 1.750" is trim-to length; however, I bought 1000 pieces of Once fired FC brass of which a majority are around 1.740" after sizing and expanding, some above this and some below this length as well.
Question is: do I trim all pieces down to the shortest case or set the trimmer to Speers recommendation and give the short cases a "pass" on trimming? I would like a uniform batch but don't want to trim too short.
Question is: do I trim all pieces down to the shortest case or set the trimmer to Speers recommendation and give the short cases a "pass" on trimming? I would like a uniform batch but don't want to trim too short.