Hey guys ,
i just got my first press this week ( rcbs rock chucker ) and the .223 die sets.
i run a few trials to learn the steps but i found a small issue in my result.
Basically after resizing my neck come out at 6.1mm instead of 6.43mm ( 0.24inch) before bullet seating.
i check my setup ans everything is normal. Should i worry about that gap in sizing ?
thanks !
peter
i just got my first press this week ( rcbs rock chucker ) and the .223 die sets.
i run a few trials to learn the steps but i found a small issue in my result.
Basically after resizing my neck come out at 6.1mm instead of 6.43mm ( 0.24inch) before bullet seating.
i check my setup ans everything is normal. Should i worry about that gap in sizing ?
thanks !
peter